-
Categories
HVAC Equipment & Parts
- Air Handlers
- Air-To-Water Heat Pumps
- Condensate Overflow Shut-off Switches
- Condensate Removal & Management
- Condenser Pads
- Condensers (Outdoor Units)
- E-Z Traps
- Electric Heat Kits
- Furnaces
- Gas Furnace and A/C Systems
- Gas-Fired Unit Heaters
- Geothermal Units
- Goodman Replacement Parts
- Heat Pumps
- Indoor Units
- Install & Duct Tape
- Installation Accessories
- Linesets
- Miscellaneous Supplies
- Mounting Brackets
- Mr. Cool Universal Series
- Packaged Units
- Portable AC and Heat Units
- Refrigerant Coils
- Secondary Drain Pans
- Service Parts
- Sheet Metal Duct & Fittings
- Surge Protection
- Thermostats and Thermostat Wire
- Through The Wall Units
- Window Units
- More categories
Mini-Splits & Accessories
- Concealed Indoor Units
- Ducted Air Handler
- Ducted Mini-Split Air Handler
- Ductless Accessories
- Electric Heater Module
- Indoor Ceiling Cassettes
- Indoor Wall Mounted
- Intelli-HEAT Coil
- Mini Split Wire & Cable
- Mini-Split Risers
- Mr. Cool Ductless Mini-Splits
- Outdoor Units, Multi-Zone
- Outdoor Units, Single-Zone
- More categories
ICM Controls ICM870-16A Soft Start, Built-in Start Capacitor, Over/Under Voltage Monitoring, Over-Current Protection, Current 16A
ICM Controls ICM870-16A Soft Start, Built-in Start Capacitor, Over/Under Voltage Monitoring, Over-Current Protection, Current 16A
General specs
- Product codeICM870-16A
- ManufacturerICM Controls
- SKUICM870-16A
Dimensions
- Dimensions7.60in x 3.20in x 2.10in
- Weight1.00lb
ICM Controls ICM870-16A Soft Start, Built-in Start Capacitor, Over/Under Voltage Monitoring, Over-Current Protection, Current 16A
Description:
The ICM870 is intended for marine, recreational vehicle (RV), residential and commercial applications.
The ICM870 integrates compressor or motor in-rush current over startup time, thus reducing peak current demand on a power supply source, such as a generator.
The ICM870 will monitor system health including voltage, current, compressor startup and self integrity.
Upon a fault condition, the ICM870 will halt operation and initiate a 4-minute anti-short cycle routine while providing diagnostic fault information by means of an LED indicator.
General Features:
Reduces in-rush current/draw necessary at startup by up to 70%
Prolongs the life of A/C by reducing excessive torque, wear and tear
Built-in 4-minute delay on start
Reduces loud noises, light flickering, and breaker trips
Built-in self-learning algorithm
Over-current protection
Over/under voltage monitoring
Built-in start capacitor
LED fault indicators
Ultrasonically sealed tamper-proof enclosure
Installation hardware is included
Specifications:
Product Type | Starter |
Inputs | L1 & L2 |
Nominal Voltage | 90 VAC min, 264 VAC max |
Over Voltage Limits | 115 VAC nominal = 140 VAC 240 VAC nominal = 250 VAC |
Under Voltage Limits | 115 VAC nominal = 95 VAC 240 VAC nominal = 195 VAC |
Outputs | Compressor |
Current Maximum Nominal | 22 FLA, 84 LRA |
Storage Temperature | -40°F to 149°F (-40°C to 65°C) |
Operating Temperature | -40°F to 131°F (-40°C to 55°C) |
Humidity | 0-95%, non-condensing |
Enclosure | IP65 |
Amperage | 16 Amps |
Over current limit | ICM870-16A = 20A |
Replaces:
The ICM870-9A and ICM870-16A models replace the amperage corresponding models from the following manufacturers:
Dometic (SmartStart) |
Hyper Engineering (Sure-Start) |
Micro-Air (EasyStart) |
Network RV (SoftStartRV) |
Carlo Gavazzi (SmoothStarter) |
Dimensions:
Product Height (in.): 2.10”
Product Width (in.): 3.20”
Product Length (in.): 7.60”
Unit Weight: 1 lbs.